Alvarion Wi^2 AP CLI Spécifications télécharger pdf (Page 202)

176 Wi² Controller CLI Reference Guide

Chapter 2 - CLI Commands

2.36 Controlled Mode Wireless Interface

Context

Context path: View > Enable > Controlled Network AP > Controlled

Network > CN Wireless interface

View > Enable > Controlled Network AP Group > Controlled Network >

CN Wireless interface

View > Enable > Controlled Network Base Group > Controlled Network

> CN Wireless interface

Configuration for wireless interfaces.

distance

Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200

distance (small | medium | large)

Sets the distance between access points.

Use this parameter to adjust the receiver sensitivity of the Controller. This

parameter should only be changed if:

• you have more than one wireless access point installed in your location

• you are experiencing throughput problems

In all other cases, use the default setting of Large.

If you have installed multiple Controllers, reducing the receiver sensitivity

of the Controller from its maximum will help to reduce the amount of

crosstalk between the wireless stations to better support roaming clients. By

reducing the receiver sensitivity, client stations will be more likely to

connect with the nearest access point.

transmit power

Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200

transmit power (DB | max)

Sets the maximum transmission power of the wireless radio.

Parameters

<db> Power is specified in steps of 1dBm. The maximum

setting is 18 dBm.

Note: The actual transmit power used may less than the value specified. The

Controller determines the power to used based on the settings you made for

regulatory domain, wireless mode, and operating frequency.

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 211 212

Pas de commentaire

Alvarion Wi^2 AP CLI Spécifications Page 202