Alvarion Wi^2 AP CLI Spécifications Page 66

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 212
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 65
40 Wi² Controller CLI Reference Guide
Chapter 2 - CLI Commands
snmp-server trap community
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
snmp-server trap community <str>
Sets the password required by the remote host that will receive the trap.
no snmp-server trap community
Deletes the password required by the remote host that will receive the trap.
snmp-server trap destination
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
snmp-server trap destination <host> <[port number]>
Add a new trap destination.
no snmp-server trap destination <host> [<port>]
Deletes the specified trap destination.
Parameters
<host> Sets the IP address or domain name of the host that
the Controller will send traps to.
<[port number]> SNMP port number. Range 1 - 65535. By default port
162 is used
snmp-server trap heartbeat
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
snmp-server trap heartbeat
Enables sending of heartbeat traps at regular intervals.
no snmp-server trap heartbeat
Disables sending of heartbeat traps at regular intervals.
snmp-server trap link-state
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
snmp-server trap link-state
Send a trap when the link state changes on any interface.
no snmp-server trap link-state
Do not send this trap.
snmp-server trap snmp-authentication
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
snmp-server trap snmp-authentication
Send a trap each time an SNMP request fails to supply the correct
community name.
Vue de la page 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 211 212

Commentaires sur ces manuels

Pas de commentaire